How to do Mercedes W205 engine online coding with vxdiag Benz C6 DOIP/ sdconnect C5 / C4.

Communication with control unit ‘N3/10 -Motor electronics ‘MED40’ for combustion engine ‘M274′(ME)’ is being established.

Version information.

Error codes.

Actual values.

Actuations.

Adaptations.

Updating of SCN coding-> an online connection is okay.

Determination of user authorization.

Message from central system.

Vehicle data are being requested from headquarters, please wait.

Coding of control unit “Motor electronics ‘MED40’ for combustion engine ‘M274’.

The SCN coding sequence has been completed successfully.

Enjoy!

Latest Benz diagnostic software Xentry 2019.09 has been tested and verified working great with VXDIAG Benz C6 and VCX Plus systems by Autonumen.com engineer.

Software version: 2019.09

Requirement: update your C6 VCI DoIP or VCX  to latest firmware version. Check here.

Software including:

Xentry/DAS 2019.09

WIS

EPC

DTS Monaco

StartFinder

SDMedia

VX Manager

Compatible device: VXDIAG Benz C6 DoIP and VCX PLUS for Benz

Xentry language list:

Update method:

1.Buy a new HDD/SSD

2. Send back old HDD/SSD to update. Freight is on your own account

How to Configure BMW ICOM Next WLAN to enable WiFi connection?

1. Run ITool Radar to detect ICOM information

2. Open IE browser and enter ICOM configuration address (based on current real ICOM IP )

3. Select WLAN Settings
Enter WiFi settings
Save Changes.

4. Disconnect LAN cable and restart ICOM, then ICOM will auto connect with WiFi .

5. If using our ICOM software and USB-WIFI, enter configuration as following:
Mode:802.11n,2.4GHz
SSID:ISAP
Security Type: WPA2 Personal
Pre‐shared Key: BmwAp24h